Mold does not appear on its own, it follows moisture that was never fully dried. Prime Water Recovery pairs certified mold remediation with structural drying protocols, so we address the growth in your Allston, MA property and the conditions that caused it.
Removing visible mold without correcting the underlying moisture problem is a temporary fix at best. Our technicians begin every job with a moisture source investigation, tracing the water intrusion back to its origin, whether that is a roof leak, a plumbing failure, condensation from poor ventilation or a prior flood that was never fully dried.
Once the source is identified and addressed, we set up negative air containment to prevent spores from spreading to unaffected areas, then remove and dispose of contaminated materials following industry protocols. HEPA air scrubbers run throughout the process to capture airborne particles, and every job concludes with structural drying to bring the space back to a moisture level that will not support new growth.
Fifteen years of remediation work across Allston, MA has shown us that clearance testing matters as much as the physical removal. We do not consider a project complete until post remediation verification confirms the space meets acceptable air quality standards.
Containment, removal and structural drying for mold growth of any size, from isolated patches to widespread contamination.
Antimicrobial treatment and disinfection of affected surfaces to reduce bacteria and contaminants following a moisture event.
Commercial de humidification equipment maintains proper humidity levels to prevent mold from returning after remediation.
Extraction of any active water source that may be feeding continued mold growth in walls, subfloor or crawl spaces.
Immediate response to active leaks or intrusion that, left untreated, would otherwise become a future mold problem.
Mold assessment and remediation for offices, schools and multi tenant buildings throughout Allston, MA.
We inspect visible growth and use moisture meters to locate hidden sources behind walls and under flooring.
Negative air chambers isolate the work area so spores cannot travel to unaffected rooms during removal.
Contaminated materials are removed and surfaces are treated with EPA registered antimicrobial solutions.
Independent clearance testing confirms air quality has returned to acceptable levels before we close the job.
We fix the moisture problem that caused the mold, not just the visible surface growth.
Clearance testing is performed to confirm the work meets recognized indoor air quality standards.
HEPA filtration and full containment protect occupants and adjacent spaces throughout the project.
You receive photo documentation and lab results, useful for insurance claims and property records alike.
If mold covers an area larger than a few square feet, or if it followed a water event, professional remediation with containment is the recommended path.
Coverage depends on the cause. Mold resulting from a sudden covered event like a burst pipe is often included, while long term neglect typically is not.
Most residential jobs are completed in three to seven days depending on the extent of growth and the drying time required afterward.
Yes, independent clearance testing is available to confirm the space meets acceptable air quality standards before you move back in.
Mold spreads while it is ignored. Speak with a certified technician today and get a clear plan for remediation and structural drying.
Call 1 (877) 264-5920